This is a NOS, new old stock, cast iron crank handle for a grinder, pump, sheller, or other hand cranked implement. It is part number Z448 and I believe it is for an Enterprise meat grinder. It is in excellent condition with no cracks, breaks, or repairs. It is fresh from the basement of an old hardware store. It measures about 10 1/2 inches long and has a tapered hole for the shaft of the implement that is 3/4″ on the back and 11/16″ on the front. It is ready to go to work for you! These cranks are quite tough to find in the wild or even at swap meets so if you need one to complete a restoration here it is. It would surely make cranking your meat grinder or other implement easier! The pictures tell the story. I can be reached at 262 573 193 1 if you’d like to talk about it. Good Luck.
This is a NOS, new old stock, cast iron crank handle for a grinder, pump, sheller, or other hand cranked implement. It is part number Z448 and I believe it is for an Enterprise meat grinder. It is in excellent condition with no cracks, breaks, or repairs. It is fresh from the basement of an old hardware store. It measures about 10 1/2 inches long and has a tapered hole for the shaft of the implement that is 3/4″ on the back and 11/16″ on the front. It is ready to go to work for you! These cranks are quite tough to find in the wild or even at swap meets so if you need one to complete a restoration here it is. It would surely make cranking your meat grinder or other implement easier! The pictures tell the story. I can be reached at 262 573 193 1 if you’d like to talk about it. Good Luck.
Wico model X take off. Has spark at points and through a test wire and plug. cap has 1 corner cracked off but doesnt effect function and is on bottom so not very noticeable. this is a short lug so most styled John Deeres. This unit is a TAKEOFF please dont expect new internals. there was no reason to go deeper into the mag as it functions.